SUSCRÍBETE A NUESTRO BOLETÍN DE CORREO ELECTRÓNICO
Siga leyendo, manténgase informado, suscríbase y le invitamos a que nos diga lo que piensa.
+8618144082725
El filtro de aceite VOLVO 478736 es equivalente a Fleetguard LF3675, LF4112, LF667, VOLVO 21707133, Atlas Copco 1614727300, Baldwin B76-SS. Número de pieza: 478736 Nombre de la parte: Filtro de aceite Reemplazar la marca: VOLVO
El filtro de aire VOLVO 11033998 es equivalente a Baldwin RS3826, Donaldson P777871, Fleetguard AF25619, MANN C321900. Número de pieza: 11033998 Nombre de la parte: Filtro de aire Reemplazar la marca: VOLVO
El filtro de aire Toyota Cabin 88508-20060 es equivalente al Toyota 88508-20070. Número de pieza: 88508-20060 Nombre de la parte: Filtro de aire de cabina Reemplazar la marca: Toyota
El filtro de combustible Toyota 23390-51070 es equivalente a Fleetguard FF5765, Toyota 23390-51020, 23390-51070. Número de pieza: 23390-51070 Nombre de la parte: Filtro de combustible Reemplazar la marca: Toyota
El filtro de aire Toyota 17801-74020 es equivalente a Fleetguard AF4959, Baldwin PA2041, GMC 25098522. Número de pieza: 17801-74020 Nombre de la parte: Filtro de aire Reemplazar la marca: Toyota
El filtro de aire CAT 208-9066 es equivalente a Donaldson P631511, New Holland 87443713. Número de pieza: 208-9066 Nombre de la parte: Filtro de aire Reemplazar la marca: CAT
One: start inspection and preparation 1: Before using the water separator equipment, the driver's consent should be obtained. 2: Check the line installation of the fuel water separator, whether the steering of the supporting pump is normal 3: Water is supplied to the fuel water separator, and the top air valve is opened to allow air to escape. 4: Check the oil and water separation in the marrow water inlet and outlet system without any leakage Two: precautions during operation 1: Adjust the drain valve opening degree and keep the pressure inside the separator to facilitate the elimination of the oil in the separator. 2: Observe whether the gauges such as pressure gauges and thermometers are normal. 3: Observe the working condition of the treated drainage water quality and oil concentration alarm 4: After the discharge is over, it should continue to be poured into clean water for 15 minutes to clean the separator. 5: Close the inlet and outlet after the pump is stopped, avoid the loss of clean water in the cylinder, reduce the oxidation and corrosion of the inner wall. 6: Each time the fuel water separator is used for discharge, it should be recorded in the oil beauty record book. Three: maintenance 1: Regularly clean the filter, open the bottom of the separator to vent, and remove the sediment deposited in the lower part, impurities 2: Clean the internal separation components of the separator in time, and avoid cleaning the inner wall and components of the separator with a cleaning agent. 3: When a fault occurs, the cause should be identified and the failed coalescing component should be replaced in time.
Siga leyendo, manténgase informado, suscríbase y le invitamos a que nos diga lo que piensa.
